Aceroinoxidable----3CR12 Stainless Steel
Over the years T.S. Industrial has superimposed numerous materials to our product providing, the most recent addition being that of 3CR12 stainless-steel.
3CR12 stainless-steel was developed as a superior substitute to coated low-carbon steel, corrosion resistant Cor-ten material and to Al, with a lifetime of just about 250 times that of unpainted low-carbon steel in sure environments.
With 3CR12 being weld in a position through typical strategies that T.S. Industrial has been perfecting for years, this material has match right in to our main focus: The Rolling of Welded Steel Open Sections and Profiles.
3CR12 will but have a downside because it isn\'t as corrosion resistant as higher atomic number 24 containing materials like CS304 stainless-steel and CS430 stainless-steel. the utilization of 3CR12 stainless-steel ought to therefore be wherever aesthetic appearances don\'t seem to be as vital.
T.S. Industrial is in a position to roll kind welded structural sections from 3CR12 material. we are able to roll spherical, sq. and rectangular tubes likewise as non-welded sections like lip channels, steelangle and flat bar from the 3CR12 material.
Although we tend to square measure ready to assist you along with your 3CR12 enquiries, T.S. Industrial doesn\'t stock spherical sq. and rectangular cold rolled tubes, lip channels or passage factory-made from 3CR12 material. so minimum order quantities might apply.
Advantages of 3CR12 stainless-steel as belowing:
|
Advantage |
Description |
|
Corrosion Resistant |
3CR12 has 250 time the life of uncoated mild steel. |
|
Weld able |
3CR12 can be welded to other ferrous metals with relative ease. |
|
Formability |
Roll forming, bending and pressing can be applied to 3CR12 even though this stainless steel is stronger than mild steel. |
Chemical Composition of 3CR12
|
|
%C |
%Si |
%Mn |
%P |
%S |
%Cr |
%Ni |
|
3CR12 |
0.03 |
1 |
2 |
0.004 |
0.03 |
12.5 |
1.5 |
Mechanical Properties of 3CR12:
|
Wall Thickness (mm) |
Proof Stress (MPa) |
Tensile Strength (MPa) |
Elongation (%) |
Brinell Hardness |
|
<3 |
280min |
460 min |
18 min |
220 max |
|
3-4.5 |
300 min |
460 min |
18 min |
220 max |
|
>4.5 |
300 min |
460 min |
20 min |
220 max |
Key Words: Stainless Steel Plates, Stainless Sheet 304, aceroinoxidable, Stainless Strip